Clean out the excess dust, and re-secure the access door with the hair pin cotters. To clear the dust collection system:ī) Turn the saw on its side, so the bottom, open part ofĬ) Open the dust access door shown in Figure 24 by After extended use, the saw’s dust collection system may become clogged. If the saw is used on a table or other surface without an opening on the bottom, clean out the base and accumulated saw dust after each cut. However, some dust will fall inside the base. If the saw is operated without a vacuum attached, most of the dust will be blown out the dust collection port. For best results, connect a vacuum to the port at the rear of the saw. Your table saw is equipped with a dust shroud and dust collection port. Be sure to place the guard and standard throat plate back in position and check adjustments when the dado cuts are complete. DO NOT USE WIDER COMBINATIONS.ĬAUTION: Always check dado blade clearance before Maximum dado width on this saw is 13/16" (20mm). use several successive passes rather than attempting to make it with one pass. Use EXTREME care when using the dado without the guard. When using the dado, the guard must be removed. A dado cut is commonly used to add support and line up a shelf for a cabinet, bookcase or some such project. Anytime a cut is required that is considerably wider than the saw kerf, a dado is used. When using the dado, the special dado insert (also sold as an accessory) must be used.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |